| Guide for Inspection: | Coach Manufacturer________________________ |
| The Following Items Should Be Inspected | Coach Number____________________________ |
| on Every Coach of Each Order | Test Location_____________________________ |
|
Item |
Requirement |
Inspection |
Result |
Inspector/ |
Remarks/Notes |
|---|---|---|---|---|---|
|
Curb Weight |
Maximum curb weight of lb. | Measure on certified scale |
Weight |
||
|
FMVSS Stickers |
Affixed to vehicle | Locate sticker |
Pass/Fail |
||
|
Finish and Color |
Smooth body surfaces and paint | Visually inspect all surfaces for flaws |
Pass/Fail |
||
|
Interior Panel Fastening |
Absence of rough edges or surfaces | Visually inspect for proper installation |
Pass/Fail |
||
|
Towing Devices |
Provision of towing eyes (front/rear) | Verify presence of towing eyes |
Pass/Fail |
||
|
Door Control |
Opening time of sec. | Verify door opening time frame |
Pass/Fail |
||
|
Interior Lighting |
Lighting operable without engine | Switch on all interior lights |
Pass/Fail |
||
|
Exterior Lighting |
All vehicle lights operable | Switch on and verify lamps are on |
Pass/Fail |
||
|
Fuel Tank |
Fill rate and filler location | Inspect filler for easy access and check fill rate |
Pass/Fail |
||
|
Chassis |
Welds, axles, suspension, steering, wheels, and brakes | Inspect for leaks, and interference. Check fluid levels, welds, undercoating, air lines, brake slack, and lug nuts |
Pass/Fail |
||
|
Electrical |
Wiring and junction boxes | Inspect for loose or stretched wires |
Pass/Fail |
||
|
Batteries |
Secured and polarized wiring access for jump start | Inspect compartment and jumper cable access |
Pass/Fail |
||
|
HVAC |
Capacity and performance | Operate AC, check compressor, condenser, flow, and temperature |
Pass/Fail |
||
|
Wheelchair Access |
Clear lift or ramp access, and securement area | Operate lift or ramp, inspect operation, measure areas |
Pass/Fail |
||
|
Power Plant |
Mounting and arrangement | Check for loose lines, leaks, and noises. Check fluid levels, belt alignment, and cap fit |
Pass/Fail |
SAMPLE ROAD TEST SHEET
| Guide for Inspection: | Coach Manufacturer________________________ |
| The Following Items Should Be Inspected | Coach Number____________________________ |
| on Every Coach of Each Order | Test Location______________________________ |
|
Item |
Requirement |
Inspection Instruction |
Result |
Inspector/Date |
Remarks/Notes |
|---|---|---|---|---|---|
|
Engine |
N/A |
Record low idle, fast idle, and high idle speeds | Low Fast High |
||
|
Service Brakes |
Stopping distance | Verify function and indicator, check for pulling to either side |
Pass/Fail |
||
|
Parking Brake |
N/A |
Verify indicator, and no movement |
Pass/Fail |
||
|
Turning Effort |
Steering wheel torque | Check effort with coach stopped |
Pass/Fail |
||
|
Turning Radius |
Not to exceed at corner of body | Verify turning radius in both directions |
Pass/Fail |
||
|
Acceleration |
rate from 0 to mph |
Verify acceleration on smooth road |
Pass/Fail |
||
|
Resonance |
Absence of audible and/or visible vibrations | Operate coach at various speeds, check for vibrations and rattles |
Pass/Fail |
||
|
Windshield Wipers |
Evenly deposited wash fluid | Operate coach at safe speed over 40 mph, check coverage, parking position, and wiper frequency |
Pass/Fail |
||
|
Power Plant |
N/A |
Check for leaks under coach and in engine compartment, check for abnormal noises |
Pass/Fail |
||
|
HVAC |
Interior temperature | Operate system, check internal and ambient temp. | Int. Amb. |
||
|
Door Control |
Accelerator and brake interlocks | At speeds less than 10 mph, verify accelerator and brake interlocks with door open |
Pass/Fail |
||
|
General |
N/A |
During testing, observe any abnor-malities in ride and handling of coach |
Pass/Fail |